Dickson WiZARD2 Replaceable Sensor Logger
Caractéristiques
| Composant | Description |
|---|---|
| Replaceable Sensor™ | Firmly plugs into the logger, ensuring proper contact. |
| Piles | 4 C type batteries required for operation. |
| Adaptateur secteur | Used to power the unit along with batteries. |
Avis important
Please follow the steps below before using your chart recorder for the first time.
Set Chart
- Appuyez deux fois sur MENU.
- Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
- Appuyez sur MENU pour enregistrer.
- Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
- Appuyez sur MENU pour enregistrer.
Régler l'heure
- Appuyez sur MENU.
- ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
- Appuyez sur MENU pour enregistrer.
- Press HOME. Pens will move onto the chart to begin recording.
Opération
Pour commencer l'opération
- Retirez le capuchon de protection du stylo.
- Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
- Insert Batteries (4 C type) and plug into AC adapter.
- Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
- Press the power button and follow the display prompts to configure. Note: Unit may power on automatically when AC and battery power are applied.
FAQ
-
What should I do if the unit does not power on?\
Ensure that both the AC adapter is plugged in and the batteries are correctly installed.
Documents / Ressources
 |
Dickson WiZARD2 Replaceable Sensor Logger [pdf] Guide de l'utilisateur WiZARD2 Replaceable Sensor Logger, WiZARD2, Replaceable Sensor Logger, Sensor Logger, Logger |