Baseus BS-CH001 10000mAh Car Jump Starter and Power Bank User Manual

Introduction

The Baseus BS-CH001 is a versatile device designed to provide emergency jump-starting for 12V vehicles and serve as a portable power bank for charging electronic devices. With a 10000mAh capacity and a peak current of 1000A, it offers a reliable solution for unexpected car battery issues and on-the-go power needs. This manual provides essential instructions for safe and effective use.

Note: Product images and videos are not included in this manual due to a discrepancy between the product description and the available media assets.

Contenu du colis

Veuillez vérifier que le colis contient les éléments suivants :

• 1 x Baseus Car Jump Starter
• 1 x Smart Jump Starter Clamp Cable (with red and black alligator clips)
• 1 x câble de charge USB vers Type-C

Caractéristiques principales

• Haute performance : 10000mAh capacity, 12V start voltage, 500A starting current, and 1000A peak current.
• Multifonctionnel: Acts as both a car jump starter and a portable power bank.
• Démarrages fiables : Capable of starting a car up to 50 times on a single full charge.
• Affichage intégré : Digital screen shows the remaining battery level of the jump starter.
• Résistance aux températures extrêmes : High-performance polymer battery cells ensure operation in very low and high temperatures.
• Sécurité avancée : Features 9 levels of protection including overcharge, voltage stabilization, short circuit, over-discharge, reverse connection, and over-temperature protection.
• Faible consommation en veille : Retains up to 85% of stored energy after one year of non-use.
• Lumière LED intégrée : Can be used as an emergency flashlight.
• Portable: Compact size and technical parameters allow it to be carried on an airplane.

Consignes de sécurité

Veuillez lire attentivement toutes les consignes de sécurité et les instructions avant d'utiliser ce produit. Le non-respect de ces instructions peut entraîner un choc électrique, un incendie et/ou des blessures graves.

• Ne pas démonter, modifier ou réparer l'appareil.
• N'exposez pas l'appareil à la pluie ou à l'humidité.
• Do not use the device if the battery clampLes câbles ou câbles sont endommagés.
• Assurez-vous de respecter la polarité de connexion (clignotant rouge).amp à positif, noir clamp (à la valeur négative) pour éviter les courts-circuits.
• Tenir hors de portée des enfants.
• Ne démarrez pas une batterie gelée.
• Ne connectez pas le positif et le négatif clamps ensemble.
• Utilisez l'appareil dans un endroit bien aéré.
• Remove the jump starter from the car battery immediately after starting the vehicle.
• Rangez l'appareil dans un endroit frais et sec lorsqu'il n'est pas utilisé.

Setup: Charging the Jump Starter

Before first use, fully charge the jump starter. It is recommended to charge the device every 3-6 months to maintain battery health, even when not in use.

1. Connect the provided USB to Type-C charging cable to the Type-C input port on the jump starter.
2. Connect the other end of the USB cable to a suitable USB power adapter (e.g., 5V/2.4A, not included).
3. The digital display will show the charging progress. Charge until the display indicates 100%.
4. Une fois complètement chargée, débranchez le câble de charge.

Operating Instructions: Car Jump Starting

Suivez attentivement ces étapes pour démarrer votre véhicule à l'aide de câbles :

1. Étape 1 : Connectez le Smart Clamp Câble

   Insert the smart jump starter clamp cable into the EC5 interface of the Baseus jump starter. The flashing red and green lights on the clamp indicate it's ready for connection to the car battery.

2. Step 2: Connect to Car Battery

   Open your car's hood. Connect the red positive (+) clamp to the positive (+) terminal of your car battery. Connect the black negative (-) clamp raccordez le câble à la borne négative (-) de votre batterie de voiture. Assurez-vous d'une connexion bien serrée.
3. Step 3: Start the Vehicle

   Return to your car and start the engine. If the car does not start immediately, wait a few seconds and try again. Do not crank the engine for more than 3 seconds at a time, and wait at least 30 seconds between attempts.

4. Étape 4 : Déconnecter

   Once the car engine starts, immediately remove the smart jump starter clamp cable from the car battery terminals, then disconnect it from the jump starter. Do not drive with the jump starter connected.

Operating Instructions: Power Bank Function

The Baseus BS-CH001 can also be used to charge your electronic devices.

1. Connect your device's charging cable (e.g., USB to Type-C, USB to Lightning) to the USB output port on the jump starter.
2. Connectez l'autre extrémité du câble à votre appareil électronique.
3. The jump starter will automatically begin charging your device. The digital display will show the remaining power.
4. Once charging is complete, disconnect your device and the cable.

Entretien

• Nettoyez l'appareil avec un chiffon doux et sec. N'utilisez pas de nettoyants abrasifs ni de solvants.
• Rangez le démarreur dans un endroit frais et sec, à l'abri de la lumière directe du soleil et des températures extrêmes.
• For optimal battery life, fully charge the device at least once every 3-6 months.
• Gardez le clamp cables clean and free from corrosion.

Dépannage

Caractéristiques

Garantie et assistance

This product comes with a standard manufacturer's warranty. For detailed warranty information, please refer to the warranty card included in your product packaging or visit the official Baseus website. For technical support, troubleshooting assistance, or to inquire about replacement parts, please contact Baseus customer service through their official channels.

Note: No specific warranty period or support contact information was provided in the product data. Please refer to the manufacturer's official resources.