1. Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your EMOS ZM4328 TORI LED Ceiling Light. This 15W LED light features a microwave motion sensor, providing 1500 lumens of 4000K neutral white light. It is designed for both indoor and outdoor use, including damp environments, thanks to its IP54 rating. Please read these instructions carefully before installation and retain them for future reference.
Figure 1: EMOS ZM4328 TORI LED Ceiling Light with 3 Years Warranty indication.
2. Consignes de sécurité
- Sécurité électrique : L'installation doit être effectuée par un électricien qualifié, conformément aux normes électriques locales. Assurez-vous que l'alimentation électrique est coupée avant toute installation ou intervention.
- Voltage: This product operates on a 230V AC power supply.
- Classement IP54 : The light is protected against dust ingress and splashing water from any direction. This makes it suitable for damp locations and outdoor sheltered areas, but not for submersion.
- Source de lumière : The LED light source is integrated and not user-replaceable. Do not attempt to disassemble the light source.
- Température de fonctionnement : Ensure the operating environment is within the specified temperature range to prevent damage.
3. Contenu du colis
Vérifiez que tous les composants sont présents avant de commencer l'installation :
- 1x EMOS ZM4328 TORI LED Ceiling Light with MW Sensor
- Mounting accessories (screws, wall plugs, foam pads)
Figure 2: Included mounting accessories.
4. Configuration et installation
Suivez ces étapes pour une installation correcte :
- Débrancher l'alimentation : Avant de commencer, assurez-vous que l'alimentation électrique principale de la zone d'installation est coupée au niveau du disjoncteur.
- Préparez la surface de montage : Choose a suitable location on a ceiling or wall. The light is suitable for indoor and outdoor use, including bathrooms, hallways, kitchens, balconies, and terraces.
- Fixer le support de montage : Remove the mounting bracket from the back of the light fixture. Use the bracket as a template to mark drilling points on the surface. Drill holes and insert wall plugs if necessary. Secure the mounting bracket to the surface using the provided screws.
Figure 3 : Arrière view avec support de montage.
- Câblage : Connect the main power supply cables to the terminal block inside the light fixture. Ensure correct polarity (Live, Neutral). The terminal block is designed for secure connections.
Figure 4: Wiring terminal connection points.
- Secure Light Fixture: Once wiring is complete, carefully attach the light fixture to the mounting bracket, ensuring it is securely fastened.
- Restaurer l'alimentation : Switch the main power supply back on.
5. Mode d'emploi
The EMOS ZM4328 TORI LED Ceiling Light features an integrated microwave motion sensor for automatic operation.
Fonctionnalité du capteur de mouvement
- The microwave motion detector reacts to movement within a range of up to 6 meters.
- Unlike traditional PIR sensors, microwave sensors can detect movement even through thin doors, window glass, or thin walls, offering broader coverage.
- The light will automatically turn on when motion is detected and turn off after a set delay if no further motion is detected.
Adjusting Sensor Settings (DIP Switches)
The light features DIP switches to adjust sensitivity, detection range, and hold time. These switches are typically located on the side of the fixture, accessible by opening a small cover.
Figure 5: DIP switches for sensor configuration.
Refer to the markings next to the DIP switches for specific settings related to:
- Portée de détection : Adjusts the maximum distance at which motion is detected.
- Temps de maintien : Sets the duration the light remains on after the last detected motion.
- Daylight Sensor (Lux Level): Determines the ambient light level at which the sensor becomes active. For example, you can set it to only activate when it's dark.
Note: Always disconnect power before adjusting DIP switches to avoid electrical hazards.
6. Entretien
- Nettoyage: To clean the light fixture, ensure the power is off. Use a soft, damp cloth. Do not use abrasive cleaners or solvents, as these can damage the finish or diffuser.
- Protection contre les insectes : The high IP54 protection class prevents mosquitoes or flies from entering the lamp, reducing the need for internal cleaning.
- Aucune pièce réparable par l'utilisateur : The LED light source is integrated and not designed for user replacement. Do not attempt to open the sealed unit beyond accessing the wiring and DIP switches.
7. Dépannage
If you encounter issues with your EMOS ZM4328 TORI LED Ceiling Light, refer to the following common problems and solutions:
| Problème | Cause possible | Solution |
|---|---|---|
| La lumière ne s'allume pas. | Pas d'alimentation électrique. Câblage incorrect. Réglage du capteur de luminosité trop élevé. | Vérifiez le disjoncteur et le raccordement électrique. Verify wiring connections (Live, Neutral). Adjust the daylight sensor (Lux) setting on the DIP switches. |
| La lumière reste allumée en permanence. | Mouvement continu détecté. Hold time setting too long. Dysfonctionnement du capteur. | Veillez à ce qu'aucun mouvement constant ne se produise dans la zone de détection. Adjust the hold time setting on the DIP switches to a shorter duration. Si le problème persiste, contactez l'assistance. |
| La lumière s'allume et s'éteint trop fréquemment. | Sensibilité trop élevée. Detection range too wide. | Reduce the sensitivity and/or detection range using the DIP switches. |
| Le capteur ne détecte aucun mouvement. | Sensibilité trop faible. Detection range too narrow. Capteur de blocage d'obstruction. Daylight sensor setting too low (light always on). | Increase sensitivity and/or detection range via DIP switches. Ensure no large metal objects or thick walls are directly in front of the sensor. Adjust the daylight sensor (Lux) setting. |
8. Spécifications
| Marque | ÉMOS |
| Numéro de modèle | ZM4328 |
| Dimensions (Diamètre x Hauteur) | 220 mm x 53 mm (environ 8.66 po x 2.09 po) |
| Poids | 622 grammes (environ 1.37 lb) |
| Pouvoir | 15 watts |
| Flux lumineux | 1500 lumens |
| Température de couleur | 4000 Kelvin (Blanc neutre) |
| Indice de rendu des couleurs (IRC) | 80 |
| Incandescent Equivalence | 100 watts |
| Voltage | 230 Volts AC |
| Indice de protection IP | IP54 |
| Matériel | Acrylonitrile Butadiene Styrene (ABS), Plastic diffuser |
| Caractéristiques spéciales | Microwave Motion Detector, Energy-saving, Waterproof |
| Classe d'efficacité énergétique | E (on new scale from 1.9.2021) |
Figure 6 : Dimensions du produit.
Figure 7: Energy Efficiency Label (Class E).
9. Garantie et assistance
Garantie
This EMOS ZM4328 TORI LED Ceiling Light comes with a Garantie de 3 ans À compter de la date d'achat, veuillez conserver votre preuve d'achat pour toute réclamation au titre de la garantie. La garantie couvre les défauts de matériaux et de fabrication dans des conditions normales d'utilisation.
Assistance clientèle
For technical assistance, warranty claims, or any questions regarding your product, please contact your retailer or the EMOS customer service department. Contact information can typically be found on the product packaging or the official EMOS website.
