Introduction
This user manual provides essential information for the safe and efficient operation, installation, and maintenance of your Candy CSWS 4962DWE/1-S washer dryer. Please read these instructions carefully before using the appliance and retain them for future reference. Proper use ensures optimal performance and extends the lifespan of your appliance.
Configuration et installation
Before operating your new washer dryer, ensure it is correctly installed according to these guidelines.
1. Déballage
Carefully remove all packaging materials. Inspect the appliance for any transit damage. Report any damage to your retailer immediately. Keep packaging materials out of reach of children.
2. Removing Transit Bolts
The appliance is fitted with transit bolts to prevent internal damage during transport. These must be removed before use. Locate the bolts at the rear of the machine, typically four. Use a spanner to loosen and remove them. Keep the bolts for future transport if needed. Insert the plastic caps provided into the holes.
3. Positionnement de l'appareil
Place the washer dryer on a firm, level floor. Ensure there is adequate ventilation around the appliance. Avoid placing it on carpeted floors where ventilation openings might be obstructed. Do not install the appliance in areas where the temperature may fall below freezing.
4. Nivellement
Adjust the adjustable feet at the bottom of the appliance to ensure it is perfectly level. Use a spirit level to verify. A level appliance reduces vibration and noise during operation.
5. Raccordement à l'eau
Connect the cold water inlet hose to a cold water tap with a 3/4" thread. Ensure the connection is tight to prevent leaks. Do not use old hoses; always use the new hoses supplied with the appliance.
6. Raccordement du drain
Position the drain hose at a height between 60 cm and 100 cm from the floor. Ensure the hose is not kinked or obstructed. It can be hooked over a sink or connected to a dedicated drain pipe.
7. Connexion électrique
Branchez l'appareil sur une prise électrique mise à la terre. Assurez-vous que le volumetagLa tension et la fréquence doivent correspondre aux spécifications indiquées sur la plaque signalétique. N’utilisez pas de rallonges ni d’adaptateurs multiples.
Image : Avant view of the Candy CSWS 4962DWE/1-S washer dryer. This image displays the appliance's control panel, detergent drawer, and large front-loading door.
Image : inclinée view of the Candy CSWS 4962DWE/1-S washer dryer. This perspective shows the side profile and depth of the appliance, highlighting its compact design.
Mode d'emploi
Follow these steps for effective washing and drying of your laundry.
1. Panneau de configuration terminéview
The control panel features a program selector dial, a digital display, and various function buttons for temperature, spin speed, delay start, and drying options.
2. Chargement du linge
Open the door and load items loosely into the drum. Do not overload the machine. For washing, the maximum capacity is 9 kg. For drying, the maximum capacity is 6 kg. Ensure no items are caught in the door seal before closing.
Image : Intérieur view of the washer dryer drum. This close-up shows the stainless steel drum with its perforations, designed for efficient washing and drying.
3. Ajout de détergent et d'additifs
Pull out the detergent drawer. Add detergent to the main wash compartment and fabric softener to the designated compartment. Follow detergent manufacturer's recommendations for dosage.
4. Sélection d'un programme
Turn the program selector dial to choose the desired wash program. Available programs include Cotton, Synthetics, Delicates, Wool, Quick Wash (e.g., 14 minutes), and Steam functions. Refer to the program chart in the full manual for detailed descriptions.
5. Options de réglage
Use the function buttons to modify program settings such as wash temperature, spin speed (up to 1400 rpm), and delay start. Select the drying level (e.g., Extra Dry, Cupboard Dry, Iron Dry) or a timed drying cycle if using the drying function.
6. Démarrage du cycle
Appuyez sur le bouton « Démarrer/Pause » pour lancer le programme sélectionné. L’écran affichera le temps restant.
7. Fin du cycle
At the end of the cycle, the appliance will signal with an audible tone or a message on the display. The door will unlock after a short delay. Remove laundry promptly to prevent creasing.
Entretien et soins
Un entretien régulier garantit des performances optimales et une hygiène parfaite de votre appareil.
1. Nettoyage du tiroir à lessive
Retirez régulièrement le bac à lessive et rincez-le à l'eau courante pour éliminer tout résidu de lessive. Nettoyez le boîtier du bac à l'aide d'une brosse.
2. Nettoyage du filtre
The appliance has a pump filter (at the bottom front) and a lint filter (for drying). Regularly clean the pump filter to prevent blockages. Place a shallow container beneath the filter cover to catch any residual water. Unscrew the filter, remove any debris, and rinse it. For the lint filter, clean it after every drying cycle by removing lint buildup.
3. Nettoyage du tambour
Run a maintenance wash cycle (e.g., a hot wash with no laundry and a descaling agent) periodically to clean the drum and remove any residue or odors.
4. Nettoyage de l'extérieur
Essuyez les surfaces extérieures de l'appareil avec un chiffon doux et sec.amp chiffon. N'utilisez pas de nettoyants abrasifs ou de solvants.
5. Joint de porte
After each wash, wipe the door seal to remove any lint or moisture, which helps prevent mold and odors.
Guide de dépannage
Refer to this section for solutions to common issues. If the problem persists, contact customer service.
L'appareil ne démarre pas.
- Assurez-vous que la fiche d’alimentation est correctement insérée dans la prise.
- Vérifiez que la porte est bien fermée.
- Verify that the 'Start/Pause' button has been pressed.
- Check if a program has been selected.
L'eau ne se remplit pas
- Assurez-vous que le robinet d’eau est complètement ouvert.
- Check if the water inlet hose is kinked or blocked.
- Verify that the water supply is not interrupted.
L'eau ne s'écoule pas
- Vérifiez si le tuyau d'évacuation est plié ou bouché.
- Clean the pump filter for any obstructions.
- Ensure the drain hose is positioned correctly (between 60-100 cm height).
Vibrations/bruit excessifs
- Ensure the appliance is perfectly level by adjusting the feet.
- Verify that all transit bolts have been removed.
- Check if the load is unbalanced; redistribute laundry in the drum.
Drying Ineffective
- Ensure the drying capacity (6 kg) is not exceeded.
- Nettoyez le filtre à peluches.
- Check if the selected drying program is appropriate for the fabric type and desired dryness level.
Caractéristiques
| Fonctionnalité | Spécification |
|---|---|
| Marque | Bonbons |
| Numéro de modèle | CSWS 4962DWE/1-S (31010535) |
| Dimensions (L x l x H) | 60 x 55 x 85 cm |
| Poids | 67 kg |
| Capacité de lavage | 9 kg |
| Capacité sèche | 6 kg |
| Vitesse d'essorage maximale | 1400 tr/min |
| Classe d'efficacité énergétique | E |
| Matériau du tambour | Acier inoxydable |
| Voltage | 220 Volts (CA) |
| Type de contrôle | Bouton |
| Type d'accès | Chargement frontal |
| Dossier spécial | Moteur à onduleur |
Garantie et assistance
Your Candy CSWS 4962DWE/1-S washer dryer comes with a manufacturer's warranty. Please refer to the warranty card provided with your appliance for specific terms and conditions, including coverage duration and what is included. Keep your proof of purchase for warranty claims.
Pour toute assistance technique, commande de pièces détachées ou prise de rendez-vous pour une intervention, veuillez contacter le service client de Candy. Vous trouverez leurs coordonnées sur le site officiel de Candy. website or in the documentation supplied with your appliance. When contacting support, please have your model number (CSWS 4962DWE/1-S) and serial number ready.
