Introduction
The Hirisi Tackle XT1 is a motion-activated security device designed to monitor your surroundings, particularly useful for carp fishing and camping. It features an integrated infrared sensor with a 120-degree detection angle. When motion is detected within its range, the device activates visual and audible alerts to notify you of approaching individuals or animals. The XT1 can be configured for sound and light alerts or light-only alerts, offering flexibility for various situations.
Contenu du colis
- 1 x Hirisi Tackle XT1 Motion Detector
Installation
1. Installation de la batterie
The XT1 requires 3 x 1.5V AAA alkaline batteries (not included). To install the batteries:
- Repérez le couvercle du compartiment à piles à l'arrière de l'appareil.
- Retirez délicatement le couvercle.
- Insérez trois piles AAA en veillant à respecter la polarité (+/-) indiquée à l'intérieur du compartiment.
- Replacez soigneusement le couvercle du compartiment à piles.
Image: Battery compartment with cover removed, showing where to insert AAA batteries.
2. Montage de l'appareil
The XT1 is designed to be mounted on a bankstick using its standard 3/8-inch thread. For optimal performance, mount the device at a height of approximately one meter (3.3 feet) to ensure the sensor has a clear line of sight.
Image: The XT1 motion detector in an outdoor setting, demonstrating its detection range.
Mode d'emploi
1. Marche/Arrêt
To turn the device on or off, press and hold the power button located on the side of the unit for 3 seconds.
2. Réglage du volume
To adjust the volume, short press the power button. The device offers 7 adjustable volume levels. Continue short pressing until your desired volume is reached.
3. Détection et alertes
Once powered on, the XT1's infrared sensor will monitor an area with a 120-degree angle and a detection distance of 2-4 meters. When motion is detected:
- A red LED light on top will illuminate steadily, and a light will flash.
- The high-output speaker will emit an audible tone (if not in silent mode).
- Simultaneously, a signal is sent to your receiver (if paired).
4. Silent Mode (LED Only)
The device can be set to operate with only LED alerts and no sound. Refer to the volume adjustment steps; one of the settings will correspond to silent operation with visual alerts only.
Image : Côté view of the XT1, indicating the on/off and volume control button.
Image : détaillée views of the sensor and side LED lights on the XT1.
Entretien
- Nettoyage: Essuyez l'appareil avec un chiffon doux et sec. N'utilisez pas de nettoyants abrasifs ni de solvants.
- Remplacement de la batterie : Replace batteries when the device's performance diminishes or if it fails to power on. Always use fresh AAA alkaline batteries. Remove batteries if the device will not be used for an extended period to prevent leakage.
- Stockage: Conservez l'appareil dans un endroit frais et sec, à l'abri de la lumière directe du soleil et des températures extrêmes.
Dépannage
| Problème | Cause possible | Solution |
|---|---|---|
| L'appareil ne s'allume pas. | Piles mortes ou mal installées. | Vérifiez la polarité des piles. Remplacez-les par des piles AAA neuves. |
| Aucun son ne sort de l'appareil. | Volume set to minimum or silent mode. | Short press the power button to increase volume. Ensure it's not in silent (LED-only) mode. |
| Poor detection range or false alarms. | Obstructions, incorrect mounting height, or environmental factors. | Ensure a clear line of sight for the sensor. Mount at approximately 1 meter height. Avoid placing near heat sources or moving foliage. |
| LEDs not flashing/illuminating. | Device not powered on or faulty unit. | Ensure the device is powered on. If the issue persists after checking batteries, contact customer support. |
Caractéristiques
- Modèle: XT1
- Marque: Hirisi Tackle
- Fabricant: HIRISI
- Source d'alimentation : Alimenté par batterie
- Type de batterie : 3 x 1.5V AAA Alkaline (not included)
- Angle du capteur : 120 degrés
- Distance de détection : 2 à 4 mètres (6.5 à 13 pieds)
- Niveaux de volume : 7 adjustable steps
- Montage: 3/8-inch thread for bankstick
- Dimensions du colis : 13.5 x 8.1 x 4.7 cm (5.3 x 3.2 x 1.85 pouces)
- Poids: 70 grammes (2.5 onces)
- ASIN: B07VM8QCB1
- Code à barres : 028753605747
Garantie et assistance
For warranty information or technical support, please refer to the documentation provided with your purchase or contact Hirisi Tackle customer service directly. Contact details can typically be found on the manufacturer's official websur le site ou auprès de votre détaillant.
