Manuel d'utilisation du fauteuil roulant pliable bariatrique large MAKJUNS Electra 7 HD

1. Introduction

This manual provides essential information for the safe and effective operation, maintenance, and care of your MAKJUNS Electra 7 HD Wide Bariatric Foldable Wheelchair. Please read this manual thoroughly before initial use and retain it for future reference. The Electra 7 HD is a portable power wheelchair designed for individuals requiring mobility assistance, featuring a 400 lbs weight capacity, 12-inch rear tires, a 21-inch wide seat, and two 250W motors.

2. Consignes de sécurité

Always prioritize safety when operating the wheelchair. Failure to follow safety guidelines may result in injury or damage to the device.

• Ensure the wheelchair is fully unfolded and locked into position before use.
• Portez toujours la ceinture de sécurité fournie.
• Ne dépassez pas la capacité de poids maximale de 400 lb.
• Avoid operating the wheelchair on excessively steep inclines or declines beyond its specified capabilities.
• Be aware of your surroundings and avoid obstacles.
• Gardez les mains et les vêtements éloignés des pièces mobiles.
• Ensure batteries are properly charged and connected before operation.

3. Configuration et assemblage

Your Electra 7 HD wheelchair comes largely pre-assembled. Follow these steps for initial setup:

1. Déplier le fauteuil roulant : Gently pull the backrest upwards until the frame locks into place. Ensure all locking mechanisms are secure.
2. Attaching the Joystick Controller: The joystick controller can be mounted on either the left or right armrest. Slide the controller onto the designated bracket until it clicks securely. Connect the controller cable to the corresponding port, typically located under the armrest.
3. Connexion des piles : The wheelchair comes with two battery packs. Locate the battery compartments, usually under the seat or at the rear. Insert the batteries and ensure they are securely connected to the power cords.
4. Réglage du repose-pieds : Adjust the footrest to a comfortable position for the user.
5. Roues anti-basculement : Ensure the anti-tip wheels are properly installed and adjusted for stability, especially when navigating inclines.

Figure 3.1 : Face avant view of the Electra 7 HD wheelchair, showing the joystick controller on the left armrest.

4. Mode d'emploi

The Electra 7 HD is designed for intuitive operation. Familiarize yourself with the joystick controller before operating the wheelchair.

1. Marche/Arrêt : Press the power button on the joystick controller to turn the wheelchair on or off. The battery indicator lights will illuminate.
2. Réglage de la vitesse: Use the speed adjustment buttons (+/-) on the joystick to select your desired speed level. Start with a low speed until comfortable.
3. Contrôle directionnel : Gently push the joystick in the desired direction (forward, backward, left, right). The wheelchair will respond smoothly. Release the joystick to stop.
4. Tournant: The wheelchair offers a great 360-degree turning circle for excellent maneuverability in tight spaces.
5. Terrain Navigation: The large 12-inch rear tires and powerful 250W motors provide good traction for navigating various terrains, including slight inclines and uneven surfaces.
6. Mode manuel : To push the wheelchair manually without power, engage the manual brake and pull out the clutches on both sides of the wheelchair. This disengages the motors, allowing the chair to be pushed.

5. Pliage et transport

The Electra 7 HD is designed for easy folding and transport.

1. Ensure the wheelchair is powered off.
2. Lift the lever at the back of the seat and gently push the backrest forward until the chair folds compactly.
3. Once folded, the wheelchair can be easily lifted and stored in a vehicle trunk or other storage space.

Figure 5.1: The wheelchair is shown folded from the side, demonstrating its compact design for storage and transport.

6. Entretien

Un entretien régulier garantit la longévité et les performances optimales de votre fauteuil roulant.

• Nettoyage: Essuyez le cadre et le siège avec un chiffon humide.amp tissu. Évitez d'utiliser des produits chimiques agressifs.
• Entretien de la batterie: Charge batteries regularly, even if not in frequent use, to maintain battery health. Store batteries in a cool, dry place.
• Pression des pneus: Periodically check the tire pressure and inflate as needed (if applicable to pneumatic tires).
• Inspection générale: Regularly inspect all nuts, bolts, and connections for tightness. Check for any signs of wear or damage to the frame, wheels, or controller.

7. Dépannage

If you encounter issues with your wheelchair, refer to the following common troubleshooting tips:

• Le fauteuil roulant ne s'allume pas : Check if the batteries are fully charged and properly connected. Ensure the power button on the joystick is pressed.
• Wheelchair not moving: Verify that the joystick controller is securely connected. Ensure the manual brake is disengaged and the motor clutches are engaged (not in manual push mode).
• Unresponsive joystick: Check all cable connections to the joystick. If the issue persists, contact customer support.
• Bruits inhabituels : Discontinue use and inspect the wheels and motors for any obstructions or loose parts.

8. Spécifications

9. Garantie et assistance

This product is covered by a limited warranty. For specific details regarding your warranty coverage, please refer to the documentation included with your purchase or contact customer support.

Avis de non-responsabilité juridique : Returned items are shipped back at the buyer's expense unless damage occurs in the original shipment or the product is defective. All USA shipped items, that have the original packaging, excluding power mobility devices, bed packages, patient & car lifts, which are not damaged are returnable with prior approval but the buyer is charged a 25% restocking fee and return shipping costs and is not reimbursed for the original shipping costs. Power Mobility Devices, including scooters and Power Chairs, will be accepted for return following an RMA request and authorization within 20 days of the order. The buyer must pay for the shipping back to the facility and incur a 25% restocking fee. This restocking fee will not apply to damaged or defective power mobility devices. The buyer must describe in detail the issue and provide pictures of the damage due to shipping. This goes for all refused shipments as well.

For customer support, please refer to the contact information provided with your product or visit the manufacturer's official website.