Manuel d'utilisation du robinet de salle de bain à entraxe large PROFLO PFWSC6860 Alvord

Introduction

This manual provides detailed instructions for the installation, operation, and maintenance of your PROFLO PFWSC6860 Alvord Widespread Bathroom Faucet. Please read this guide thoroughly before beginning installation or use to ensure proper function and longevity of your product. Retain this manual for future reference.

Image: PROFLO brand logo, a blue oval with 'PROFLO' written in white.

Consignes de sécurité

Always observe basic safety precautions when installing or servicing plumbing fixtures. Failure to follow these instructions could result in property damage or personal injury.

• Coupez l’alimentation en eau principale avant l’installation.
• Portez des lunettes de sécurité et des gants pendant l'installation.
• S'assurer que tous les codes locaux de plomberie et de construction sont respectés.
• Ne serrez pas trop les connexions, car cela pourrait les endommager.
• Si vous avez le moindre doute concernant une quelconque étape de l'installation, consultez un plombier qualifié.

Contenu du colis

Verify that all components are present before beginning installation. If any parts are missing or damaged, contact PROFLO customer service.

• Ensemble de bec de robinet
• Hot Water Handle Assembly
• Cold Water Handle Assembly
• Ensemble de vidange escamotable
• Mounting Hardware (washers, nuts)
• Water Supply Lines (typically included or purchased separately)

Image: A chrome widespread bathroom faucet with a high-arc spout and two separate lever handles, along with a pop-up drain rod visible behind the spout.

Caractéristiques

Installation

This section outlines the general steps for installing your widespread bathroom faucet. Specific details may vary based on your sink and plumbing setup.

1. Préparer l'évier : Ensure the sink deck has three pre-drilled holes for a widespread faucet. Clean the area around the holes.
2. Installer les poignées : Insert the hot and cold water handle assemblies into the outer holes of the sink deck. Secure them from underneath with washers and mounting nuts. Ensure the handles are oriented correctly.
3. Installation du bec de robinet : Insert the faucet spout assembly into the center hole of the sink deck. Secure it from underneath with the provided washer and mounting nut.
4. Raccorder les conduites d'eau : Connect the hot and cold water supply lines to the corresponding handle assemblies and then to your home's hot and cold water supply valves. Connect the flexible lines from the handles to the faucet spout. Hand-tighten connections, then use a wrench for a final quarter-turn. Do not overtighten.
5. Installer le drain escamotable : Follow the instructions provided with the pop-up drain assembly. Typically, this involves placing the drain body into the sink drain hole with a gasket, securing it from underneath, and connecting the lift rod mechanism to the faucet spout.
6. Test de fuites : Once all connections are secure, slowly turn on the main water supply. Check all connections for leaks. If leaks are present, gently tighten the connections until they stop.
7. Tirez la chasse d'eau : Remove the aerator from the spout. Turn on both hot and cold water for a few minutes to flush out any debris from the lines. Turn off the water, reattach the aerator.

Opération

Your PROFLO PFWSC6860 faucet features two lever handles for precise control of water temperature and flow, and a pop-up drain for basin contrôle.

• Débit d'eau : Lift the hot water handle (typically on the left) to increase hot water flow. Lift the cold water handle (typically on the right) to increase cold water flow.
• Contrôle de la température : Réglez simultanément les poignées d'eau chaude et d'eau froide pour obtenir la température d'eau souhaitée.
• Bonde de vidange escamotable : Push down on the lift rod located behind the faucet spout to close the drain and fill the basin. Pull up on the lift rod to open the drain and allow water to empty.

Entretien et nettoyage

Proper care will help maintain the finish and performance of your faucet.

• Nettoyage régulier : Nettoyez régulièrement le robinet avec un chiffon doux et du savon doux. Rincez abondamment à l'eau claire et séchez avec un chiffon doux pour éviter les traces d'eau.
• Évitez les nettoyants agressifs : N’utilisez pas de nettoyants abrasifs, de produits chimiques agressifs ni de tampons à récurer, car ils peuvent endommager la finition chromée.
• Entretien de l'aérateur : If water flow decreases or becomes irregular, the aerator may be clogged. Unscrew the aerator from the spout, clean any debris, and rinse it before reattaching.
• Nettoyage des canalisations : Periodically remove and clean the pop-up drain stopper to prevent buildup and ensure proper drainage.

Dépannage

Consultez cette section pour les problèmes courants et leurs solutions.

Garantie et assistance

PROFLO products are manufactured to high-quality standards. For warranty information or technical assistance, please contact PROFLO customer service directly. Keep your purchase receipt as proof of purchase.

For further assistance, please visit the official PROFLO webconsultez le site ou contactez leur service client.