Manuel d'utilisation du système sans fil portable Samson CR-277-HH
Model: CR-277 | Brand: SAMSON
Introduction
Thank you for choosing the Samson CR-277-HH Handheld Wireless System. This system is designed to provide reliable and high-quality audio transmission for various applications, including live performances, presentations, and public speaking. It features a dual UHF wireless receiver and two dynamic handheld microphone transmitters, ensuring clear and consistent sound.
This manual provides detailed instructions for setting up, operating, maintaining, and troubleshooting your CR-277-HH system. Please read it thoroughly before use to ensure optimal performance and longevity of your equipment.
Figure 1: The Samson CR-277-HH Handheld Wireless System, showing the CR277 dual UHF receiver and two HT7 handheld microphone transmitters.
Guide d'installation
Déballage et inspection
Carefully unpack all components and inspect them for any signs of damage. If any item is missing or damaged, contact your dealer immediately.
Le forfait doit comprendre :
- CR277 Half-Rack Dual UHF Wireless Receiver
- Two HT7 Dynamic Handheld Microphone Transmitters
- Adaptateur secteur
- Audio Cables (e.g., 1/4-inch to 1/4-inch)
- 9-volt Batteries (for transmitters)
Figure 2: Included components of the Samson CR-277-HH system, showing the receiver, two microphones, power adapter, and connecting cables.
Placement du récepteur
Place the CR277 receiver on a stable, flat surface, away from potential sources of interference such as computers, large metal objects, or other wireless devices. Ensure adequate ventilation around the unit.
Connexion du récepteur
- Connect the included power adapter to the DC input on the rear panel of the CR277 receiver and then to a suitable power outlet.
- Connect the receiver's audio outputs to your mixer, amplifier, or PA system. You can use either the two independent 1/4-inch outputs (one for each channel) or the single 1/4-inch mix output.
- Extend the tuned molded antennas for optimal signal reception.
Battery Installation (HT7 Transmitters)
Each HT7 handheld microphone transmitter requires one 9-volt battery for operation. To install the battery:
- Unscrew the bottom section of the microphone handle.
- Insert a fresh 9-volt battery, observing the correct polarity (+/-).
- Screw the bottom section back onto the microphone handle until secure.
Each transmitter is designed to operate for approximately 12 hours on a single 9-volt battery.
Mode d'emploi
Mise sous/hors tension
- Récepteur: Press the POWER button on the front panel of the CR277 receiver to turn it on. The power indicator will illuminate.
- Émetteurs : Slide the ON/OFF switch on each HT7 microphone transmitter to the 'ON' position. The power/battery indicator on the transmitter will light up.
Réglage des niveaux
The CR277 receiver features independent level controls for each channel (Ch U1 and Ch U2). Adjust these knobs to set the desired output volume for each microphone. Monitor the multi-segment RF level and peak audio indicators to ensure optimal signal strength without clipping.
Figure 3: Front panel of the CR277 receiver, highlighting the independent level controls, RF level, and peak audio indicators for each channel.
Utilisation des micros
Hold the HT7 microphone approximately 2-6 inches from your mouth for best vocal pickup. The Q7 dynamic microphone element is designed for clear and articulate sound reproduction.
Contrôle du silencieux
The CR277 receiver includes squelch control for each channel. This feature helps to eliminate unwanted noise when the transmitter signal is weak or absent. Adjust the squelch knob clockwise to increase the squelch threshold, reducing background noise. Adjust it counter-clockwise to decrease the threshold, allowing weaker signals to pass through.
Entretien
Nettoyage
To clean the receiver and microphones, use a soft, dry cloth. For stubborn dirt, a slightly damp cloth can be used, but ensure no moisture enters the internal components. Do not use abrasive cleaners or solvents.
Remplacement de la batterie
Replace the 9-volt batteries in the HT7 transmitters when the power/battery indicator on the microphone begins to dim or when audio quality degrades. Always use fresh, high-quality alkaline batteries for optimal performance and battery life.
Stockage
When not in use for extended periods, remove the batteries from the transmitters to prevent leakage. Store the system in a cool, dry place, away from direct sunlight and extreme temperatures.
Dépannage
If you encounter issues with your Samson CR-277-HH system, refer to the table below for common problems and their solutions.
| Problème | Cause possible | Solution |
|---|---|---|
| Aucun son du microphone | Transmitter off or low battery Récepteur non allumé Niveaux de volume trop bas Mauvaise connexion du câble | Ensure transmitter is ON and battery is fresh Verify receiver is powered on Increase volume on receiver and connected audio device Vérifiez toutes les connexions des câbles audio |
| Interférences ou statique | Autres appareils sans fil à proximité Antennas not properly extended Receiver too far from transmitter Squelch setting too low | Éloignez-vous des autres appareils sans fil Ensure antennas are fully extended and positioned correctly Reduce distance between transmitter and receiver Increase squelch level on receiver |
| Durée de vie de la batterie courte | Piles anciennes ou de mauvaise qualité Utilisation continue | Use fresh, high-quality alkaline 9-volt batteries Turn off transmitters when not in use |
| Distorsion audio | Niveau d'entrée trop élevé Microphone trop proche de la source sonore | Reduce volume on receiver or connected device Increase distance between microphone and sound source |
Spécifications techniques
| Fonctionnalité | Spécification |
|---|---|
| Numéro de modèle | CR-277 |
| Facteur de forme du microphone | Portable |
| Diagramme polaire | Omnidirectionnel |
| Technologie de connectivité | Sans fil |
| Nombre de canaux | 2 |
| Power Source (Transmitters) | Batterie 9 volts |
| Battery Life (Transmitters) | Environ 12 heures |
| Sorties du récepteur | Two independent 1/4-inch, one 1/4-inch mix |
| Impédance | 600 ohms |
| Poids de l'article | 1.25 kg (System) |
| Composants inclus | Batterie |
| Appareils compatibles | Camera (as per specification, though typically audio mixers/PA systems) |
| Utilisations recommandées | Karaoké |
Garantie et assistance
Samson products are manufactured to the highest standards and are backed by a limited warranty. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Samson website.
For technical support, service, or replacement parts, please contact your authorized Samson dealer or Samson customer service directly. Keep your purchase receipt as proof of purchase for warranty claims.
