Manuels+

somfy 1810636

SOMFY Situo RTS Pure Radio Wall Transmitter

Model: 1810636 (Manufacturer Model: 322147)

Introduction

This manual provides instructions for the installation, operation, and maintenance of your SOMFY Situo RTS Pure radio wall transmitter. This device is designed for the manual control of one or more radio-controlled Somfy drives, such as blinds, awnings, or roller shutters. Please read this manual carefully before using the product to ensure safe and correct operation.

Consignes de sécurité

  • Conservez l'appareil à l'abri de l'humidité et des températures extrêmes.
  • N’essayez pas d’ouvrir ou de réparer l’appareil vous-même. Confiez toute réparation à un personnel qualifié.
  • Assurez-vous que la pile est insérée correctement en respectant les indications de polarité.
  • Jetez les piles usagées de manière responsable conformément aux réglementations locales.
  • Cet appareil est destiné à être utilisé en intérieur uniquement.

Produit terminéview

The SOMFY Situo RTS Pure is a sleek, handheld radio transmitter designed for intuitive control of your Somfy RTS products.

SOMFY Situo RTS Pure Radio Wall Transmitter with up, my, and down buttons

Cette image montre la face avant. view of the SOMFY Situo RTS Pure radio wall transmitter. It is a white, rectangular device with three gray circular buttons arranged vertically in the center: an 'up' arrow, a 'my' button, and a 'down' arrow. Below the buttons, there is a small black indicator light. The Somfy logo is subtly embossed at the bottom.

Composants clés :

  • Bouton Haut (^): Moves the connected drive upwards (e.g., opens blinds).
  • My Button (my): Stops the drive or recalls a pre-programmed favorite position.
  • Bouton Bas (v): Moves the connected drive downwards (e.g., closes blinds).
  • Voyant lumineux : Provides visual feedback on commands and battery status.
  • Programming Button (rear): Used for pairing the transmitter with Somfy RTS drives.

Installation

1. Installation de la batterie

  1. Gently slide open the battery compartment cover on the back of the transmitter.
  2. Insert the supplied battery (type CR2430) ensuring correct polarity (+/-).
  3. Fermez soigneusement le couvercle du compartiment à piles.

2. Pairing with a Somfy RTS Drive

To control a Somfy RTS drive, the transmitter must first be paired. This process typically involves using an existing paired transmitter or the drive's programming button.

  1. Using an existing transmitter: Take an already programmed RTS transmitter that controls the desired drive. Press and hold its programming button (usually on the back) until the drive moves briefly.
  2. Immediately after the drive moves, take your new Situo RTS Pure transmitter. Press and hold its programming button (located on the back, often recessed) until the drive moves briefly again. This confirms successful pairing.
  3. Without an existing transmitter: Refer to the specific instructions for your Somfy RTS drive to put it into programming mode. Once the drive is in programming mode, press the programming button on your Situo RTS Pure transmitter until the drive moves briefly.

Note: If you are pairing with multiple drives, repeat the process for each drive or group of drives.

Mode d'emploi

Contrôle de base :

  • To move the drive up (e.g., open blinds), press the ^ bouton.
  • To move the drive vers le bas (e.g., close blinds), press the v bouton.
  • À arrêt the drive at any point, press the my bouton.

Setting a Favorite Position ('my' position):

  1. Move the drive to your desired favorite position using the ^ or v boutons.
  2. Once at the desired position, press and hold the my button until the drive moves briefly. This saves the position.

Recalling a Favorite Position:

  • From any position, a short press of the my button will move the drive to its pre-programmed favorite position.

Entretien

Remplacement de la batterie :

When the indicator light on the transmitter no longer illuminates or the range decreases significantly, it is time to replace the battery.

  1. Slide open the battery compartment cover on the back of the transmitter.
  2. Retirez l'ancienne pile CR2430.
  3. Insérez une nouvelle pile CR2430 en respectant la polarité (+/-).
  4. Fermez le couvercle du compartiment à piles.

Note: Dispose of old batteries according to local environmental regulations.

Nettoyage:

Nettoyez l'émetteur avec un chiffon doux et sec. N'utilisez pas de nettoyants abrasifs ni de solvants.

Dépannage

Problème Cause possible Solution
L'émetteur ne répond pas. Batterie morte. Remplacez la batterie.
Plage de fonctionnement réduite. Low battery or radio interference. Replace battery. Check for sources of interference (e.g., large metal objects, other radio devices).
Drive does not respond after pairing. Pairing unsuccessful or drive is not powered. Repeat the pairing process. Ensure the drive has power.

Caractéristiques

  • Modèle: Situo RTS Pure
  • Numéro de modèle du fabricant : 322147
  • Marque: Somfy
  • Fréquence radio: 433.42 MHz
  • Rolling Code System: Oui
  • Gamme: Approximately 20 meters (indoors, depending on environment)
  • Type de batterie : CR2430 (inclus)
  • Dimensions: 1 x 1 x 1 cm (approximate, as per product data); 60 grams
  • Utilisation prévue : Intérieur

Garantie et assistance

For warranty information and technical support, please refer to the official Somfy website or contact your local Somfy dealer. Keep your proof of purchase for warranty claims.

Ressources en ligne : www.somfy.com