1. Introduction
The HID 6005 ProxPoint Plus is a compact, high-performance 125 kHz proximity reader designed for access control applications. This reader offers reliable performance and is suitable for various indoor and outdoor environments. This manual provides essential information for the proper installation, operation, and maintenance of your device.
Image 1.1: The HID 6005 ProxPoint Plus 125 kHz Mini Mullion Proximity Reader. This image shows the compact, charcoal gray housing of the reader, designed for discreet mounting.
2. Consignes de sécurité
Please read and understand all safety instructions before installing or operating the device. Failure to follow these instructions may result in injury or damage to the product.
- Sécurité électrique : Installation should be performed by qualified personnel in accordance with all local electrical codes. Disconnect power before wiring.
- Conditions environnementales : Do not expose the reader to extreme temperatures, humidity, or corrosive environments beyond its specified operating range.
- Montage: Assurez-vous que la surface de montage est stable et peut supporter l'appareil en toute sécurité.
3. Contenu du colis
Vérifiez que tous les composants sont présents dans le package :
- HID 6005 ProxPoint Plus Reader
- Matériel de montage (vis, chevilles)
- Guide d'installation (ce document)
4. Configuration et installation
Follow these steps for proper installation of the HID 6005 ProxPoint Plus reader.
4.1 Montage
- Select a suitable mounting location, typically near a door frame or mullion.
- Use the reader as a template to mark the drilling points for the mounting screws.
- Percez des avant-trous et insérez des chevilles si nécessaire.
- Secure the reader to the mounting surface using the provided screws. Ensure the reader is flush and stable.
4.2 Câblage
The HID 6005 ProxPoint Plus reader features a pigtail cable for connection. Refer to the following wiring diagram for standard Wiegand output connections. Always ensure power is disconnected before making any wiring connections.
| Couleur du fil | Fonction |
|---|---|
| Rouge | +VDC (5-16 VDC) |
| Noir | Sol |
| Vert | Data 0 (Wiegand) |
| Blanc | Data 1 (Wiegand) |
| Brun | LED verte |
| Orange | Bip |
Connect the reader's wires to the corresponding terminals on your access control panel. Ensure all connections are secure and insulated.
4.3 Mise sous tension
Once all wiring is complete and verified, apply power to the access control system. The reader will typically emit a short beep and the LED will illuminate (normally red) to indicate it is powered on and ready for operation.
5. Mode d'emploi
The HID 6005 ProxPoint Plus reader is designed for simple and intuitive operation.
5.1 Presenting a Credential
To gain access, present a valid 125 kHz proximity card or fob directly in front of the reader. The optimal reading distance may vary slightly depending on the credential type and environmental factors.
5.2 LED and Beeper Indicators
- État normal : The LED is normally red, indicating the reader is powered and awaiting a credential.
- Lecture réussie : Upon a successful read of a valid credential, the reader will emit a short beep and the LED will flash green. This signal is then sent to the access control panel for verification.
- Invalid Read/No Response: If an invalid credential is presented or no credential is detected, the reader will remain red and typically not beep. The access control panel determines the response for invalid credentials.
6. Entretien
The HID 6005 ProxPoint Plus reader requires minimal maintenance to ensure long-term reliable operation.
- Nettoyage: Periodically wipe the reader's surface with a soft, damp Utilisez un chiffon. N’utilisez pas de nettoyants abrasifs, de solvants ou de produits chimiques agressifs, car ils pourraient endommager le boîtier.
- Inspection: Regularly inspect the reader and its wiring for any signs of physical damage or wear. Address any issues promptly.
- Micrologiciel : This reader typically does not require user-upgradable firmware. Consult your access control system administrator for any system-wide updates.
7. Dépannage
If you encounter issues with your HID 6005 ProxPoint Plus reader, refer to the following common problems and solutions.
- Reader Not Powering On (No LED, No Beep):
- Check power connections to the reader and the access control panel.
- Vérifiez le volume de l'alimentationtage est dans la plage spécifiée (5-16 VCC).
- Ensure the reader's black wire (Ground) is properly connected.
- Reader Powers On (Red LED) but Does Not Read Cards:
- Ensure you are using compatible 125 kHz proximity credentials.
- Try presenting the card at different angles and distances.
- Check for sources of electromagnetic interference near the reader.
- Verify the reader's Data 0 (Green) and Data 1 (White) wires are correctly connected to the access control panel.
- Reader Reads Cards but Access is Denied:
- This typically indicates an issue with the access control panel or the credential's programming, not the reader itself.
- Consultez le manuel ou l'administrateur de votre système de contrôle d'accès.
- LED Not Changing Color or Beeper Not Sounding on Read:
- Verify the Brown (Green LED) and Orange (Beeper) wires are correctly connected to the access control panel and configured to provide feedback.
- Check the reader's configuration settings (e.g., 'Beep On, LED Normally Red, Reader Flashes Green on Tag Read' is the default for P/N 6005BGB00).
8. Spécifications
Key technical specifications for the HID 6005 ProxPoint Plus reader:
- Nom du modèle : 6005
- Numéro de pièce : 6005BGB00
- Marque: CACHÉ
- Fréquence de fonctionnement : 125 kHz
- Sortir: Wiegand
- Couleur: Gris anthracite
- Dossier spécial : Construction durable
- Poids de l'article : Environ 1 livre (0.45 kg)
- Dimensions: Mini Mullion form factor (exact dimensions vary slightly by model, refer to product datasheet for precise measurements)
- Exigences d'alimentation : 5-16 VCC
- Température de fonctionnement : Consult product datasheet for specific range.
9. Informations sur la garantie
Warranty terms for the HID 6005 ProxPoint Plus reader are provided by the manufacturer, HID Global. Please refer to the official HID Global website or contact your authorized reseller for detailed warranty information, including coverage period and conditions. Keep your proof of purchase for warranty claims.
10. Assistance clientèle
For technical assistance, product inquiries, or support regarding your HID 6005 ProxPoint Plus reader, please contact your authorized HID Global reseller or the HID Global customer support team. You can find contact information on the official HID Global website (www.hidglobal.com).
