1. Introduction
The TrustFire L2S-SE is a powerful and reliable tactical LED flashlight designed for various outdoor activities and daily use. It features a maximum brightness of 1050 lumens and a beam range of up to 175 meters. This manual provides detailed instructions for the safe and effective use, setup, and maintenance of your L2S-SE flashlight.
2. Contenu du colis
Veuillez cocher la case correspondant aux éléments suivants :
- TrustFire L2S-SE Tactical Flashlight
- Manuel de l'utilisateur (ce document)
- 14500 Rechargeable Lithium-ion Battery (if included with purchase)
- Clip de poche
- Cordon
- Joints toriques de rechange
- Câble de charge USB Type-C
3. Spécifications
| Fonctionnalité | Détail |
|---|---|
| Numéro de modèle | L2S-SE |
| Nom de marque | TrustFire |
| Source de lumière | Ampoules LED (perles LED Q4) |
| Luminosité maximale | 1050 Lumens (with 14500 battery) |
| Portée maximale du faisceau | 175 Meters (with 14500 battery) |
| Quoitage | 15 W |
| Mode de commutation | Élevé/Moyen/Faible (2-4) File(s Support Variateur) |
| Distance focale | Non réglable |
| Zoom | Non |
| Indice d'étanchéité | IPX6 |
| Matériau du corps | Aviation aluminum AL6061-T6 (military grade hard anodizing) |
| Dimensions | 98 mm (longueur) x 20.5 mm (diamètre de la tête) x 21.5 mm (diamètre du tube) |
| Poids net | 43.2g (without battery) / 65.1g (with battery) |
| Hauteur de chute | 1 mètres |
| Certification | CE |
| Fonctionnalités supplémentaires | Faible volumetage warning, intelligent temperature control, Type-C charging |
3.1 Performance Table (Approximate Values)
Note: The following parameters are approximate values only, measured in a laboratory environment for 14500 750mAh rechargeable lithium-ion batteries, and may vary with changes in the use environment and battery.
| Mode | Brightness (14500 / Alkaline/NiMH) | Run Time (14500 / Alkaline/NiMH) | Range (14500 / Alkaline/NiMH) | Light Intensity (14500 / Alkaline/NiMH) |
|---|---|---|---|---|
| Clair de lune | 3LM/3LM | 35 heures / 55 heures | 7m / 7m | 72 CD / 12 CD |
| Milieu | 150LM/50LM | 3 heures / 5 heures | 66m / 38m | 1089 CD / 361 CD |
| Haut | 1050LM/175LM | 65 minutes / 131 minutes | 176m / 75m | 7744 CD / 1406 CD |
4. Installation
4.1 Battery Selection and Installation
The L2S-SE flashlight is compatible with both 14500 rechargeable lithium-ion batteries and standard Alkaline/NiMH AA batteries. For optimal performance and features like in-flashlight charging, a 14500 lithium-ion battery with a protective plate (e.g., TrustFire-14500 X series) is recommended.
- Dévissez le capuchon arrière de la lampe de poche.
- Insert the battery with the positive (+) end facing towards the head of the flashlight. The L2S-SE features an anti-reverse connection design to prevent damage from incorrect battery insertion.
- Revissez solidement le capuchon arrière.
Important Battery Warnings:
- Do not use batteries not provided by our store to avoid damaging the battery or flashlight.
- 14500 batteries are industrial batteries, not safe civilian batteries. Improper use (short circuit, high temperature, etc.) may cause burning or explosion, endangering personal and property safety.
- Using high-quality lithium-ion batteries with protection plates can reduce risks. TrustFire series batteries are recommended.
- Alkaline/NiMH batteries can be used, but they CANNOT be charged inside the flashlight via the Type-C port. Attempting to do so may cause damage or present a safety hazard.
4.2 Charging (for 14500 Li-ion batteries only)
If using a 14500 rechargeable lithium-ion battery, you can charge it directly within the flashlight using the provided USB Type-C cable.
- Repérez le port de chargement de type C sur le corps de la lampe torche.
- Connect the USB Type-C cable to the flashlight and a suitable USB power source (e.g., computer, wall adapter).
- The flashlight will indicate charging status (e.g., red for charging, green for fully charged).
- Une fois complètement chargé, débranchez le câble.
Note: Alkaline/NiMH batteries cannot be charged in the flashlight. Attempting to do so may cause damage or present a safety hazard.
5. Fonctionnement
The L2S-SE features a convenient one-button operation located at the tail of the flashlight.
- Marche/Arrêt : Press the tail button completely until it clicks to turn the flashlight on or off.
- Shift Gear (Brightness Modes): With the flashlight on, click the tail button repeatedly within 0.5 seconds to cycle through the brightness modes: Low → Middle → High.
- Memory Gear: If the flashlight is left on a specific brightness mode for more than 0.5 seconds before being turned off, it will remember that mode and turn on in the same mode next time.
- Mode stroboscopique : In the power-off state, quickly press the tail button halfway twice (without fully clicking) to enter strobe mode.
5.1 faible volumetage Avertissement
When the battery power is low, the flashlight will flash three times every 5 minutes to remind the user to replace or recharge the battery.
6. Entretien
- Nettoyage: Nettoyez régulièrement le corps de la lampe torche avec un chiffon doux et sec.amp chiffon. Évitez d'utiliser des produits chimiques agressifs ou des matériaux abrasifs.
- Filetages et joints toriques : Periodically lubricate the screw threads and O-rings with silicone grease to maintain waterproofing and smooth operation. Replace worn O-rings with the provided spares.
- Entretien de la batterie: Si la lampe torche n'est pas utilisée pendant une période prolongée, retirez la pile pour éviter les fuites et les dommages.
- Étanche: The L2S-SE is IPX6 waterproof, meaning it is protected against powerful water jets. While it can withstand heavy rain, it is not designed for submersion. Ensure all parts are tightly sealed before exposure to water.
7. Dépannage
| Problème | Cause possible | Solution |
|---|---|---|
| La lampe de poche ne s'allume pas. | Battery incorrectly installed or depleted. | Check battery polarity (+ end towards head). Replace or recharge battery. |
| Brightness modes do not change. | Button not clicked quickly enough or faulty. | Ensure quick, repeated clicks within 0.5 seconds. If issue persists, contact support. |
| Flashlight flashes three times every 5 minutes. | Faible volumetage avertissement. | Replace or recharge the battery immediately. |
| Infiltration d'eau. | Loose tail cap or worn O-rings. | Ensure tail cap is tightened. Inspect and lubricate/replace O-rings. Avoid submersion. |
8. Conseils d'utilisation
- Transport polyvalent : Utilize the two-way bag clip for easy attachment to pockets, belts, or bags, making it convenient for everyday carry (EDC).
- Contrôle de la température : The built-in intelligent temperature control system helps prevent overheating during prolonged use, ensuring comfort and extending the flashlight's lifespan.
- Application: The L2S-SE is suitable for various scenarios including outdoor sports, circuit maintenance, finding items in dark spaces, and daily dog walking.
9. Garantie et assistance
Pour toute information concernant la garantie, l'assistance technique ou les demandes de service, veuillez consulter le site officiel de TrustFire. webConsultez le site ou contactez votre détaillant. Conservez votre reçu d'achat comme preuve d'achat.
For the full user manual in PDF format, you can refer to the official document: TrustFire L2S-SE User Manual (PDF)
