1. Introduction
The Hyperice Hypervolt Go 2 is a portable percussion massage device designed to help relieve sore muscles and stiffness. Featuring QuietGlide Technology, this lightweight and compact device offers effective muscle recovery and relaxation on the go. This manual provides essential information for the safe and efficient use of your Hypervolt Go 2.
Figure 1: Hyperice Hypervolt Go 2 device with included attachments.
2. Ce qui est inclus
Your Hypervolt Go 2 package contains the following items:
- Hypervolt Go 2 Device
- Charging Cable (5V USB-A to USB-C)
- Two (2) Interchangeable Head Attachments
Figure 2: All components included with the Hypervolt Go 2.
3. Installation
3.1 Chargement de l'appareil
Before first use, fully charge your Hypervolt Go 2. Connect the provided 5V USB-A to USB-C charging cable to the device's charging port and a compatible power source. The LED light band at the base of the handle will illuminate to indicate charging status. A full charge provides approximately 3 hours of battery life.
Note: The Hypervolt Go 2 will not operate while connected to the charging cable.
3.2 Fixation/Détachement des accessoires de tête
To attach a head, gently push the desired attachment into the opening at the front of the device. To detach, pull the attachment straight out. Ensure the attachment is securely seated before use.
Figure 3: The two interchangeable head attachments.
Video 1: Unboxing and initial setup of the Hypervolt Go 2, demonstrating how to attach and detach the massage heads.
4. Mode d'emploi
4.1 Mise sous/hors tension
To power on the device, press and hold the power button located at the bottom of the handle for approximately 2 seconds. Release the button once the LED lights illuminate. To power off, press and hold the power button again until the device shuts down.
4.2 Réglage des paramètres de vitesse
The Hypervolt Go 2 features 3 speed settings. Once powered on, press the power button briefly to cycle through the speeds:
- Press once for Speed 1 (lowest)
- Press twice for Speed 2 (medium)
- Press three times for Speed 3 (highest)
The indicator lights around the power button will show the current speed setting.
4.3 Champ d'application
Apply the massage head to the desired muscle area. Move the device slowly over the muscle, applying light to moderate pressure. Avoid using the device on bony areas, the head, or directly on joints. Use for a maximum of 1-2 minutes per muscle group.
Figure 4: Proper application of the Hypervolt Go 2 on the arm.
Video 2: Demonstration of the Hypervolt Go 2 in use, showcasing its portability and effectiveness on various muscle groups.
5. Head Attachments
The Hypervolt Go 2 comes with two interchangeable head attachments, allowing for varied massage experiences:
- Tête plate : Ideal for larger muscle groups and general use.
- Tête de balle : Designed for more precise targeting of knots and smaller muscle areas.
Figure 5: Using the Hypervolt Go 2 with a flat head attachment on the leg.
6. Entretien
To ensure the longevity and optimal performance of your Hypervolt Go 2, follow these maintenance guidelines:
- Nettoyage: Essuyez l'appareil avec l'annonceamp chiffon doux après chaque utilisation. Ne pas immerger l'appareil dans l'eau.
- Stockage: Conservez l'appareil dans un endroit frais et sec, à l'abri de la lumière directe du soleil et des températures extrêmes.
- Chargement : Rechargez régulièrement l'appareil, même si vous ne l'utilisez pas fréquemment, afin de préserver la durée de vie de la batterie.
7. Dépannage
If you encounter any issues with your Hypervolt Go 2, consider the following:
- L'appareil ne s'allume pas : Ensure the device is fully charged. The device will not operate while plugged in.
- Percussions faibles : Check the battery level. If low, charge the device. Ensure the head attachment is securely in place.
- Bruit inhabituel : Discontinue use and contact customer support if the noise persists or is accompanied by other malfunctions.
For further assistance, refer to the official Hyperice support resources.
8. Spécifications
| Fonctionnalité | Détail |
|---|---|
| Dimensions du produit | 2.87 x 1.97 x 2.63 pouces |
| Numéro de modèle de l'article | Hypervolt Go 2 |
| Poids de l'article | 1.5 livres (680 XNUMX grammes) |
| Piles | 1 piles lithium-ion requises (incluses) |
| Source d'énergie | Alimenté par batterie |
| Matériel | Polycarbonate |
| Fabricant | Hyperice |
| Vitesses | 3 |
| Moteur | Brushless high-torque 40W motor |
| Autonomie de la batterie | 3 heures |
| Idéal pour les voyages | TSA approved carry-on |
9. Consignes de sécurité
Always follow the instructions provided to operate the device safely. Do not use this massager for conditions not listed in the 'Use for' attribute (Whole Body). Consult a health professional before use if you have any medical conditions or concerns. Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
10. Garantie et assistance
For warranty information, product support, or to purchase additional accessories, please visit the official Hyperice website or contact their customer service. Each item has a unique code that Hyperice verifies before shipping.
Visitez le Hyperice Store Pour plus de produits et d'informations.