Bissell 1134N

BISSELL Oxygen Boost Formula 1134N User Manual

For use with BISSELL SpotClean and SpotClean Pro Carpet Cleaners

1. Produit terminéview

The BISSELL Oxygen Boost Formula 1134N is a powerful cleaning solution designed to enhance the stain removal capabilities of your BISSELL SpotClean, SpotClean Pro, and Stain Eraser devices. This formula penetrates deep into carpet fibers to effectively eliminate tough marks and revitalize the appearance of your carpets and upholstery.

It is formulated to permanently remove old, ingrained stains, providing a thorough clean. The bottle itself is made with at least 25% post-consumer recycled plastic, reflecting a commitment to environmental responsibility.

BISSELL Oxygen Boost Formula 1134N bottle

Image 1.1: BISSELL Oxygen Boost Formula 1134N 1L bottle.

Important: This formula is not suitable for use on velvet, chenille, silk, Dralon, or leather materials.

2. Installation et préparation

  1. Read Your Machine Manual: Always refer to your BISSELL SpotClean, SpotClean Pro, or Stain Eraser machine's user manual for specific instructions on filling the clean water tank and mixing solutions.
  2. Mélange de la solution : Add the BISSELL Oxygen Boost Formula to your machine's clean water tank along with your primary BISSELL cleaning solution. Follow the dilution ratios specified in your machine's manual.
  3. Pre-Test: Before cleaning, always test the formula on an inconspicuous area of the carpet or upholstery for colorfastness. Allow the tested area to dry completely and check for any color change or bleeding.
  4. Direct Application (for tough stains): For particularly stubborn stains, the Oxygen Boost Formula can be applied directly to the stain before using your machine. Allow it to sit for a few minutes, then proceed with machine cleaning.
BISSELL SpotClean machine

Image 2.1: A BISSELL SpotClean machine, compatible with Oxygen Boost Formula.

3. Mode d'emploi

  1. Préparez la zone : Passez l'aspirateur sur la zone à nettoyer afin d'enlever la poussière et les débris.
  2. Appliquer la solution : Using your BISSELL SpotClean or SpotClean Pro machine, spray the cleaning solution (mixed with Oxygen Boost) onto the stained area. Ensure the area is adequately saturated.
  3. Scrub (if applicable): If your machine has a brush attachment, gently scrub the stained area to work the solution into the fibers.
  4. Extrait: Use your machine's suction feature to extract the dirty solution from the carpet or upholstery. Make slow, overlapping passes until the solution being extracted appears clean.
  5. Répéter si nécessaire : For very tough or old stains, you may need to repeat the application and extraction process.
  6. Séchage: Allow the cleaned area to dry thoroughly. Avoid walking on or placing furniture on damp tapis.

4. Maintenance et stockage

  • Stockage: Store the BISSELL Oxygen Boost Formula in a cool, dry place, away from direct sunlight and extreme temperatures.
  • Fermer le bouchon correctement : Always ensure the bottle cap is tightly sealed after each use to prevent evaporation or spills.
  • Tenir hors de portée : Gardez le produit hors de portée des enfants et des animaux domestiques.
  • Élimination: Dispose of empty bottles according to local regulations. The bottle is made with at least 25% post-consumer recycled plastic.

5. Dépannage

  • Stains Persist: If stains remain after initial cleaning, re-apply the solution and allow it to penetrate for a longer period (e.g., 5-10 minutes) before extracting. Ensure you are using the correct dilution ratio.
  • Dégâts matériels : If you notice any discoloration or damage to the cleaned surface, immediately stop use. Remember, the formula is not suitable for velvet, chenille, silk, Dralon, or leather. Always pre-test.
  • Foaming: Excessive foaming in the dirty water tank may indicate too much cleaning solution was used. Reduce the amount of formula in subsequent uses.
  • Pas d'aspiration : If your machine is not extracting properly, check your machine's manual for troubleshooting steps related to suction issues (e.g., tank levels, hose blockages).

6. Spécifications

FonctionnalitéDétail
Numéro de modèle1134N
MarqueBissell
Formulaire d'articleLiquide
Volume de l'article1 Litre (1000 Millilitres)
Dimensions du produit (L x l x H)7 x 12 x 23.8 cm
Poids de l'article1.1 kilogrammes
ParfumCoffee (Note: This may be a translation error from the source data, typically cleaning solutions are unscented or have a fresh scent)
Utilisations spécifiques du produitCarpet, Upholstery (excluding unsuitable materials)
Caractéristiques matériellesScented (refer to scent note above)
Dossier spécialConcentré
Recommandation de surfaceTapis
Matériel non utiliséSans acide
Contains Liquid SubstancesOui
Ingrédients≥ 95% water, ≥ 5% hydrogen peroxide
BISSELL Oxygen Boost Formula bottle with dimensions

Image 6.1: BISSELL Oxygen Boost Formula bottle showing approximate dimensions (10 inches / 26 cm height).

7. Consignes de sécurité

  • Tenir hors de portée : Always store this product out of reach of children and pets.
  • Contact visuel : In case of eye contact, rinse immediately with plenty of water and seek medical advice if irritation persists.
  • Contact avec la peau : En cas de contact avec la peau, laver à l'eau et au savon.
  • Ingestion: If swallowed, do not induce vomiting. Seek medical attention immediately and show this label.
  • Ventilation: Utiliser dans un endroit bien ventilé.

8. Assistance

For further assistance, product inquiries, or to report any issues, please contact BISSELL Customer Service. Refer to your BISSELL machine's manual or the BISSELL website contenant les informations de contact spécifiques à votre région.