Introduction
This manual provides detailed instructions for the installation, usage, and maintenance of your Delta 41218-ST Commercial Grab Bar. Designed for safety and durability, this 18-inch grab bar features a bright stainless steel finish and concealed mounting for a clean aesthetic. Proper installation is crucial for ensuring the product's intended safety and weight-bearing capacity.
Consignes de sécurité
- Capacité de poids : This grab bar is designed to support up to 500 livres when properly installed into structural blocking or studs. Do not exceed this weight limit.
- Installation professionnelle recommandée : If you are unsure about proper installation techniques or locating structural supports, consult a qualified professional.
- Inspection régulière : Periodically check all mounting screws and the grab bar for any signs of looseness or damage. Tighten or replace components as necessary.
- Conformité ADA : This product is ADA compliant and ANSI approved, indicating it meets specific accessibility standards when installed correctly.
Contenu du colis
Veuillez vérifier que tous les composants sont présents avant de commencer l'installation :
- Delta 41218-ST Commercial Grab Bar (18-inch, Bright Stainless Steel)
- Mounting Hardware (screws, anchors if applicable)
- Decorative Flanges (2 units)

Image: The Delta 41218-ST Commercial Grab Bar, an 18-inch bright stainless steel bar with concealed mounting plates on each end.
Instructions d'installation
Outils requis (non inclus) : Drill, drill bits, stud finder, level, measuring tape, pencil, screwdriver.
- Sélectionnez l'emplacement: Choose a wall location that provides adequate structural support (e.g., wall studs or blocking). Use a stud finder to locate and mark the center of the studs.
- Marquer les points de montage : Hold the grab bar in the desired position, ensuring it is level. Mark the screw hole locations through the mounting plates onto the wall.
- Percer des trous pilotes : Drill pilot holes at the marked locations. Ensure the drill bit size is appropriate for the provided mounting hardware.
- Secure Mounting Plates: Attach the mounting plates to the wall using the provided screws. Ensure they are securely fastened to the structural supports.
- Attach Grab Bar: Position the grab bar over the secured mounting plates. The concealed mounting design allows the bar to slide over the plates.
- Install Decorative Flanges: Slide the decorative flanges over the mounting plates until they sit flush against the wall, covering the mounting hardware.
- Sécurité des tests : Gently apply pressure to the grab bar to ensure it is firmly attached and does not wobble.
Usage
The Delta 41218-ST Grab Bar is intended to provide stable support for balance and assistance when moving within a bathroom or other areas. Always apply pressure evenly and avoid sudden, forceful impacts. Ensure hands are dry for a secure grip.
Entretien
- Nettoyage: Clean the grab bar regularly with a soft, damp cloth and mild soap. Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the bright stainless steel finish.
- Résistance à la corrosion : The high-quality finish is designed to resist rust and corrosion through everyday use. However, prompt cleaning of spills or residues will help maintain its appearance and integrity.
- Inspection: Periodically inspect the grab bar and its mounting points for any signs of wear, damage, or looseness. Address any issues immediately to ensure continued safety.
Dépannage
- Grab Bar Feels Loose: If the grab bar feels loose or wobbly, immediately cease using it for support. Re-check the mounting screws and ensure they are securely fastened to structural supports. If necessary, remove the bar and re-install, ensuring proper anchoring.
- Finish Discoloration: Ensure you are using only mild, non-abrasive cleaners. Hard water spots can often be removed with a vinegar and water solution, followed by rinsing and drying.
Caractéristiques
| Numéro de modèle : | 41218-ST |
| Marque: | DELTA FAUCET |
| Longueur: | 18 pouces |
| Diamètre extérieur : | 1-1/4 Inches (1.25 Inches) |
| Matériel: | Métal |
| Finition: | Acier inoxydable brillant |
| Capacité de poids : | Up to 500 Pounds (when properly installed) |
| Type de montage : | Caché |
| Conformité: | ADA Compliant, ANSI Approved |
Garantie et assistance
This Delta grab bar is backed by a Lifetime Faucet and Finish Limited Consumer Warranty et un 5-Year Limited Commercial Warranty. For detailed warranty information or technical support, please refer to the official Delta Faucet webConsultez leur site web ou contactez leur service client. Conservez votre preuve d'achat pour toute réclamation au titre de la garantie.
Pour obtenir de l'aide supplémentaire, visitez le Boutique DELTA sur Amazon or the official DELTA FAUCET website.